Wall and Ceiling Spray Textures provide a decorative appearance over gypsum panels and most other interior wall and ceiling surfaces. They are formulated to provide for a variety of decorative options including splatter, knockdown and orange peel designs.
MIXING - POWDER: Use a clean vessel equipped with powder agitator. For initial mix, stir powder into recommended amount of water, agitating during powder addition. Allow to soak for at least 15 minutes — longer in cold water. Remix until a creamy, lump-free mix is obtained. Adjust to spray consistency by adding small amounts of water, if necessary. Over thinning can create an undesirable finish or “soft wall” or chalky condition. Over dilution can also entrain excessive air and foam. Note that the air and mix temperature will affect viscosity.
APPLICATION: Texture should not be applied until the primer coat is thoroughly dry. Products are specifically designed for hand and spray applications. The desired pattern can be achieved by varying the viscosity of the mix, the orifice opening at the spray tip, or the air supply pressure.