Level V Wall and Ceiling Primer/Surfacer is a high quality PVA product applied in a production spray application to create a smooth wall finish that also gives mold resistance. It takes a level 4 finish to level 5 without the need to skim coat by hand. Level V allows the paint to absorb at the same rate over the entire gypsum surface by sealing the porosity between the joint compound and the wallboard paper surface which provides a uniform finish coat.
Apply with 1/4", 3/8" or 1/2" roller. The smaller the nap the less the stipple. Roll out to desired stipple which is approximately 6 mils wet. Allow to dry. Light sanding with 150-220 grit is optional. Spray-on Application: Apply Level V Wall and Ceiling Primer / Surfacer with an airless that sprays at least 1 gallon per minute, pump pressure rated at 2700-3000 psi and spray tip orifice between 0.023 and 0.031. Light sanding is option with 150-220 grit to smooth fall out or imperfections. Respirator not required but recommended. Clean tools, equipment with soapy water and rinse.