No-Coat ULTRATRIM L Trim 1/2” Drywall Corners

The No-Coat Structural Laminate (SLAM) design is a revolutionary drywall corner system that delivers superior strength and durability and eliminates costly callbacks. Whether finishing off angles, archways, inside or outside corners, No-Coat offers a complete corner system that guarantees perfect results – every time.

No-Coat ULTRATRIM Bullnose offers perfect rounded corners every time and conforms to any drywall archway.

3/8” Bullnose 8’ x 50 – 313042
3/8” Bullnose 9’ x 50 – 313043
3/8” Bullnose 10’ x 50 – 313044

3/4” Bullnose 8’ x 50 – 161072
3/4” Bullnose 9’ x 50 – 161073
3/4” Bullnose 10’ x 50 – 161074

Technical Information

Installation

1. Apply a generous amount of approved joint compound to a clean, dry surface of drywall.
2. Place the No-Coat corner onto wet joint compound and press on firmly.
3. Using a stiff 4 inch to 6 inch taping knife or an appropriate No-Coat roller, wipe very hard, squishing the excess mud out from behind the No-Coat corner trim and embedding the mud into both the paper fibers of the drywall board and the joint tape paper surface of the No-Coat corner.

• When storing ULTRATRIM corners, lay boxes flat on the floor. Leaning boxes against a wall may eventually cause the corners to warp.