No-Coat ULTRATOOLS

The No-Coat Structural Laminate (SLAM) design is a revolutionary drywall corner system that delivers superior strength and durability and eliminates costly callbacks. Whether finishing off angles, archways, inside or outside corners, No-Coat offers a complete corner system that guarantees perfect results – every time.

No-Coat rollers and applicators allow for high speed installations and flawless results.

Wide Outside 90 & Bullnose Roller – 313048
Inside 90 Roller – 313041
Outside 90 Roller – 313046
One-sided Roller – 313047
Double Barrel Hopper – 313045
Flex Bracket for Hopper – 313158

Technical Information

Installation

1. Apply a generous amount of approved joint compound to a clean, dry surface of drywall.
2. Place the No-Coat corner onto wet joint compound and press on firmly.
3. Using a stiff 4 inch to 6 inch taping knife or an appropriate No-Coat roller, wipe very hard, squishing the excess mud out from behind the No-Coat corner trim and embedding the mud into both the paper fibers of the drywall board and the joint tape paper surface of the No-Coat corner.

No-Coat has a number of installation rollers available to help insure proper embedding, depending on the product used.
The process described above is the most important part of drywall corner trim installation and must be followed correctly for the warranty to apply.